product support
wall mount sensor mirror

product support
wall mount sensor mirror

troubleshooting

Mirror doesn't charge

Reset your mirror:
1.Make sure the USB charger and USB charging cable are working. Test them using a mobile phone or a rechargeable product.
2. A full charge will take 4 to 8 hours depending on mirror model and USB charger rating.
3. If the battery level is too low, you may not see any recharge light indication for up to 10 minutes.
4. If the mirror is not able to charge after 4 hours perform mirror reset procedure.

Watch our video on how to reset your mirror.

Mirror doesn't light up

1. Reset the mirror:
    a. Turn on the mirror by pressing the on/off power button. You should see the recharge light indicator to show green briefly. If it does not, press and hold the on/off power button again.
    b. If you do not see the green light, you need to recharge the mirror.

2. Test the sensor:
    a. Clean the sensor lens using soft cloth.
    b. Place your hand 4-6 inches in front of the sensor to activate the mirror light.

3. Recharge the mirror:
    a. Recharge the mirror for at least 30 minutes and try again.
    b. If the battery level is too low, you may not see any recharge light indication for up to 10 minutes. You can test the sensor again.

Watch our video on how to reset your mirror.

Mirror won't turn off

First try this:
1. Clean the sensor with rubbing alcohol and a mircofiber cloth.
2. Make sure there is nothing interfering with the sensor.

If that doesn't work, reset your unit:
Press the power button on the bottom or the back of the unit (depending on the model) to turn it off. Leave it off for 20 seconds, and then press the power button again to turn the unit on.

Mirror light is dimming and turning off during use.

First, make sure the mirror isn't tilted at an angle that is out of the sensor range. You must be within 6-8 inches in front of the sensor (dark-tinted window on the light ring). After a short period of inactivity, light will dim and turn off automatically.

If that doesn't work, recalibrate your mirror:
1. Remove the charger from your mirror.
2. Press and hold the power button on the bottom of the unit for 10 seconds, then release.
3. Wipe the sensor using rubbing alcohol and a microfiber cloth.
4. Make sure nothing is placed in front of the mirror with a minimum 5 feet of clearance.
5. Press and hold the power button again for 10 seconds, then release.
6. Allow the mirror to sit for 1 minute while it finishes the reset.

replacement parts
glass repair service

glass repair service
REPAIR50

$50
white charger

white charger
PD6122

$14.99
mounting plate with anchors

mounting plate with anchors
PD6130

$9.99
micro-USB cable

micro-USB cable
PD6123

$9.99
instruction sheet
instruction sheet
Download the instruction sheet for your wall mount sensor mirror.
Download
warranty
contact us